|
|
 |
|
|
Reduce Cycle Time and Increase Your Productivity with ISCAR’s 'All in One' Solid Carbide Endmill
|
|
|
|
ISCAR is introducing an ‘all in one’ solid carbide endmill, which is a winning combination of three most innovative endmills: FEEDMILL, CHIP SPLITTER and CHATTERFREE.
The new EFP solid carbide endmills provide the highest advantage in cavity milling, which is especially useful in the die and mold industry.
The FEEDMILL bottom utilizes a large radius cutting edge configuration that allows for greatly increased feed rates of up to 0.5 mm/tooth, at 0.3 to 1.0 mm depth of cut. This provides a significant reduction in cycle time, which thus increases productivity. The unique cutting edge geometry axially directs the resultant cutting forces towards the spindle. This results in high stability and enables machining at high feeds, even with long overhang. This feature should be used for the penetration stage of pocket machining.
After penetration into the cavity, the chip splitting flutes should be used to widen the initial cavity. The serrated cutting edge features flat peaks which leave a better surface finish, in comparison to other rougher endmills. The chip splitting flutes also feature better force distribution combined with the CHATTERFREE variable pitch, which is the winning solution for maximum stock removal rates.
The new endmills are very effective even on low power machines (ISO40/BT40).
The EFP solid endmills are available with 4 and 5 flutes, comprised of IC903 - an ultra-fine grain substrate protected by the advanced AL-TEC coating technology. The combination of these parameters offers outstanding wear resistance and toughness.
They are useful for machining materials such as hardened steel up to 65 HRc, P20, H13, cast iron, stainless steel, titanium and high temperature alloys.
ISCAR’s new endmills will reduce cycle time and increase your productivity.
|
|
|
|
|